Power Tools Reviews

I am a very novice wood worker. I have some beginner books about "2x4 furniture" I have a circular saw, but, as you know, unless you are very experienced, executing cross cuts on lumber is not just a matter of chopping -- you have to measure, and add for the blade offset -- every time!. It was tedious, and i was close to getting a table saw or a miter saw. Fortunately, I came across this clever too -- simply line up the guide on the line where you want to cut, push the saw, and you are done.

Thumb's up!

I've had my cordless 18-volt drill for about 6 yrs. and have had zero trouble with it in almost daily usage. I purchased a second battery so I wouldn't have to stop to re-charge only one when I was working. My charger has recently stopped charging. I was needing to find only another charger and have not been able to...yet. I figured it would just be more simple to buy a whole new kit to compliment my existing equipment.

B&D-VersaPak SnakeLight! Wow! Nice! An Extra Eye! Personally I like Black & Decker's VersaPak tools for light duty hobby activities in my laboratory. I don't see well so anything that helps me with fine detail work is welcome! This tool does just that by concentrating just the right amount of light in a small space that is nonglaring. I am so pleased with my SnakeLight, I am contemplating the purchase of another! With the light comes a 3.6v Black & Decker VersaPak Screwdriver, dual port VersaPak charge and one silver VersaPak battery. Given the fact that I will most likely be using the light when using the screwdriver, it would have been nice if they would have included TWO Batteries! I won't hold that against them as you get what you pay for! Now, shall I purchase another?

I have tried various products to protect my cast iron and steel tool table surfaces and this is by far the most effective. Spray liberally onto the surface, let it soak it for a few minutes and wipe the excess off. The Boeshield (invented by Boeing for aircraft use) has kept my power tools rust-free for two years now.

Used this hammer drill to bore 1-1/4 inch holes for lag bolts in foundation. Took about 5 minutes per hole when drilling to 6 inch depth. Probably would have taken less time with a sharper carbide bit, but Bosch has a powerful tool for what is a brutal job. Vibration while still present was less than I expected

This hammer works great,its accurate and strong. I highly recommend it to everyone who is in the market for one, you can't go wrong. Bosch is an excellent brand!!

I have yet to find another tool by any manufacturer that impresses me as much as Bosch tools, they have the best tools in the industry. I'm impressed everytime I use these tools. Highly recommended!

Used this tool to remove tile over concrete, a 3 inch thick mortar bed and tons of tiled cement on the walls (again 3 inches thick with metal mesh.) A 2 week miserable job by hand takes 2 hours with this tool. It is tough, powerful, and easy to use. The variable speed trigger is great for exerting the mid range thumping to remove large chunks of mortar. Came with two included chisel bits. A great value and very underated tool, I am thrilled with it. I chose this over the combo hammer/rotation drills because I wanted more power and emphasis on the vibrational demolition function since I already had a rotational hammer drill. Based on reading other reviews and carefully reading impact specs I am unsure if those combo units can do the job as well as this focused single purpose demolition hammer.

i have two other brands, their is no comparison....

Combination of hard pad and dust collection make this the best half sheet. I've used the Makita, Milwaukee, and Porter Cable and they can't match up for finish sanding. Good reliable product that sands flat and won't round at the edges/corners. I reecommend it atop the rest.