Router Bits Reviews

The Dremel 326D 6-Piece High Speed Cutter Set is a good addition to your Dremel bit collection and works like a charm.

If you are into wood working and need some great bits, buy them here.

I think that these pieces are a great addition to anyones workshop. They work great for sanding in those hard to reach areas and the saws make great finishing cuts. I think that if you have to buy for someone that has a dremel this is the perfect gift. They are great for outlining body parts of animal cutouts. This is the best cutting and carving set that I've used. I hope this helps you decide on what you think of this set.

I had a miter saw blade that I had used without cleaning for over 10 years, BladeSaver removed the wood tar build-up in seconds. The blade looks like new!

I have used a number of router 3/4" straight router bits, from Bosch, CMT, Ohldham and Woodcraft. Nothing holds an edge like the freud bits have. I use them to route dado's in anything from pine, maple and oak. They cost less than the CMT bits and hold an edge 25 0 40% longer. If you need it, get it, nothing beats it that I have used.

freud router bits are the best and this one is no exception. i only use freud and they leave a smooth finish behind and stay sharp a long time. cant go wrong with this bit.

Freud Bits are the longest lasting and most durable bits in the business. I have used cheaper bits but none of them lasted longer than a project or two. The Freud router bits that I have used are as good as new after many years of use. I count on them for precision performance and long lasting value.

I like router bits that produce chips. This one does that. I don't like bits that burn when you stop for a moment--this one is pretty good about not burning too.

I haven't used it enough to talk about reliability, although Freud is one of the best ones out there, and also one of the few to make (actually the only one I found) this size bit.

I do lots of channel routing which requires many passes to achieve the desired width. This Freud bit does the trick EVERY time! Rarely any kickback (and if there is any - it's normally caused by a stupid move on my part) and clean routs every time. I love it and the rest of my Freud bits. HIGHLY RECOMMENDED!

Cutting tounge and groove when replacing floor boards in my 100 year old house, has never been easier since I bought this bit. I set it up on my router table, and go. I cut the boards for my entire upstairs hallway in about 30 minutes, including set up time. Its easy to use and adjust, and comes sharp and ready to use. I bought this bit because of the Freud name, and I'm happy I've stuck with them...